Table of Contents
Advertisement
5.
To save the changes, choose one of the following:
• Click Apply to save the changes and keep the Edit Security dialog open. Click OK to close the Edit
Security dialog.
• Click OK to save changes and close the Edit Security dialog.
Viewing properties of a security set, group, or member
To view the properties of a security set, group, or member from the faceplate display, perform the following
procedure:
1.
Click Security on the tool bar, or select Security > Edit Security to open the Edit Security dialog.
2.
Choose one of the following:
• Click a security set, security group, or security group member. Select Edit > Properties.
• Right-click on a security item In the graphic window. Select Properties from the popup menu.
3.
View the security information for the selected item in the Properties dialog.
4.
Click OK to close the dialog.
Security Config dialog
Use the Security Config dialog, shown in
to non-volatile or to temporary memory, and to require the domain ID of a switch be validated before
attaching to the fabric.
Figure 18
Security Config dialog
To configure switch security from the faceplate display, perform the following procedure:
1.
Select Security > Edit Security Config to open the Security Config dialog.
2.
Select the Auto Save option to enable (default) or disable Auto Save mode.
If enabled, the security configuration is saved to non-volatile memory on the switch. If disabled, the
security file is saved only to temporary memory. The Auto Save feature is used when Fabric Binding is
enabled. When Auto Save is disabled, any updates from remote switches will not be saved locally. If
the local switch is reset, it may isolate.
Select the Fabric Binding Enabled option to require the expected domain ID of a switch to be verified
3.
before being allowed to attach to the fabric.
NOTE:
this feature, it is best to set the switch state to offline, enable the fabric binding feature on all
switches, and then set the switch state to online.
4.
Click OK to save the settings and close the Security Config dialog.
36
Managing fabrics
The fabric binding feature must be enabled on all switches in the fabric. When enabling
Figure
18, to save the active security configuration on the switch
Advertisement
Table of Contents
