HP AA-RW20A-TE User Manual page 173

SNMP
Prompts you in a line-by-line fashion to change SNMP configuration settings.
the SNMP fields. For each parameter, enter a new value or press Enter to accept the current
value shown in brackets.
Table 51 SNMP configuration settings
Entry
SNMPEnabled
Contact
Location
Trap [1-5] Address
Trap [1-5] Port
Trap [1-5] Severity
Trap [1-5] Version
Trap [1-5] Enabled
ReadCommunity
WriteCommunity
TrapCommunity
AuthFailureTrap
ProxyEnabled
Description
Enables (True) or disables (False) SNMP on the switch. The default is True.
Specifies the name of the person to be contacted to respond to trap events.
The name can be up to 64 characters excluding #, semicolon (;), and
comma (,). The default is undefined.
Specifies the name of the switch location. The name can be up to 64
characters excluding #, semicolon (;), and comma (,). The default is
undefined.
Specifies the workstation IP address to which SNMP traps are sent. The
default address for trap 1 is 10.0.0.254. The default address for traps
2–5 is 0.0.0.0. Addresses, other than 0.0.0.0, for all traps must be
unique.
Specifies the workstation port to which SNMP traps are sent. Valid
workstation port numbers are 1–65535. The default is 162.
Specifies the severity level to use when monitoring trap events. The default
is Warning.
Specifies the SNMP version (1 or 2) to use in formatting traps. The default
is 2.
Specifies whether traps (event information) are enabled or disabled
(default).
Read community password that authorizes an SNMP agent to read
information from the switch. This is a write-only field. The value on the
switch and the SNMP management server must be the same. The read
community password can be up to 32 characters excluding #, semicolon
(;), and comma (,). The default is "public".
Write community password that authorizes an SNMP agent to write
information to the switch. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The write
community password can be up to 32 characters excluding #, semicolon
(;), and comma (,). The default is "private".
Trap community password that authorizes an SNMP agent to receive traps.
This is a write-only field. The value on the switch and the SNMP
management server must be the same. The trap community password can
be up to 32 characters excluding #, semicolon (;), and comma (,). The
default is "public".
Enables (True) or disables (False) the generation of traps in response to
trap authentication failures. The default is False.
Enables (True) or disables (False) SNMP communication with other
switches in the fabric. The default is True.
McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide 173
Table 51 describes