Remove The Server From The Rack - HP ProLiant DL160 Gen8 User Manual

After performing the installation or maintenance procedure, slide the server back into the rack, and then
3.
press the server firmly into the rack to secure it in place.
WARNING:
latches and sliding the server into the rack. The sliding rails could pinch your fingers.

Remove the server from the rack

To remove the server from an HP, Compaq branded, Telco, or third-party rack:
If installed, remove the rack bezel (on page 59).
1.
Power down the server (on page 17).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
To reduce the risk of personal injury, be careful when pressing the server rail-release
Operations 18