Remove The Server From The Rack - HP ProLiant ML30 Gen10 Plus User Manual

Remove the server from the rack

Remove the server from the rack
Prerequisites Prerequisites
Before you perform this procedure, review the:
Rack warnings and cautions
Server warnings and cautions
A fully populated chassis is heavy. Hewlett Packard Enterprise recommends removing the external chassis components before
removing the server from the rack.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
5. Slide the server tray out of the rack:
a. Loosen the server tray thumbscrews (callout 1).
b. Grasp the tray notch and slide the server out of the rack (callout 2).
6. Remove the server from the tray.
Remove the server from the rack 36