Remove The Server From The Rack - HP Apollo 4200 Gen9 Maintenance And Service Manual

Pull the release lever to disengage the drive from the backplane, and then slide the drive out of the
d.
drive bay.

Remove the server from the rack

WARNING:
equipment:
Observe local occupational health and safety requirements and guidelines for manual
handling.
Reduce the weight of the server by removing the drives and power supplies before installing or
removing the server from the rack
Obtain adequate assistance to lift and stabilize the server during installation or removal. HP
recommends that a minimum of four people are required for installing or removing the server
from the rack. A fifth person might be required to help align the server if the server is installed
higher than chest level
Use caution when installing or removing the server from the rack; it is unstable when not
fastened to the rails.
WARNING:
modules, and the internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause ESD.
Back up all server data.
1.
Press the Power On/Standby button.
2.
The server powers down and enters standby mode. The system power LED changes from green to
amber. Power is still applied to the server.
Disconnect all peripheral cables from the server.
3.
Release the power cords from the strain relief straps.
4.
This server is very heavy. To reduce the risk of personal injury or damage to the
To reduce the risk of personal injury from hot surfaces, allow the drives, power input
To prevent damage to electrical components, properly ground the server before
DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 27