Processor - HP ProLiant ML310 Generation 4 Maintenance And Service Manual

Install the heatsink.
3.
CAUTION:
"X" pattern).
Install the system fan air baffle.
4.
Install the access panel.
5.
Install the bezel
6.

Processor

CAUTION:
processor and heatsink useless. Clean the component with the provided alcohol swab, then
add thermal grease.
IMPORTANT:
processor.
NOTE:
To remove the component:
Power down the server (on page 25).
1.
Remove the server from the rack, if necessary
2.
Remove the bezel
3.
Remove the access panel
4.
Remove the system fan air baffle
5.
Remove the heatsink ("Heatsink" on page 37).
6.
Heatsink retaining screws should be tightened in diagonally opposite pairs (in an
("Unlock the tower bezel" on page 26).
Removal of the processor or heatsink renders the thermal layer between the
If upgrading processor speed, update the system ROM before installing the
PPM 1 is embedded in the system board.
("Unlock the tower
("Access panel" on page 26).
("System fan air
("Remove the server from the
bezel" on page 26).
baffle" on page 26).
rack" on page 25).
Removal and replacement procedures 39