Hot-Plug Sas Or Sata Backplane - HP ProLiant ML310 Generation 4 Maintenance And Service Manual

Disconnect the power and data cables.
7.
Remove the hot-plug hard drive cage.
8.
NOTE:
replacement hard drive cage.
To replace the component, reverse the removal procedure.

Hot-plug SAS or SATA backplane

To remove the component:
Power down the server (on page 25).
1.
Remove the server from the rack, if necessary
2.
Remove the bezel
3.
Remove the access panel
4.
Remove all hot-plug hard drives
5.
Remove the hard drive cage fan and baffle
6.
Disconnect the power and data cables.
7.
Remove the hot-plug hard drive cage
8.
If replacing only the hard drive cage, retain the backplane for use with the
("Unlock the tower
("Access panel" on page 26).
("Hot-plug SAS and SATA hard
("Remove the server from the
bezel" on page 26).
("Hard drive cage fan and
("Hot-plug SAS and SATA hard drive
rack" on page 25).
drives" on page 29).
baffle" on page 28).
cage" on page 30).
Removal and replacement procedures 31