Non-Redundant Power Supply - HP ProLiant ML310 Generation 4 Maintenance And Service Manual

Remove the redundant power supply backplane assembly.
9.
To replace the component, reverse the removal procedure.

Non-redundant power supply

To remove the component:
Power down the server (on page 25).
1.
Remove the server from the rack, if necessary
2.
Remove the bezel
3.
Remove the access panel
4.
Remove the system fan air baffle
5.
Remove the hard drive cage fan and baffle
6.
Disconnect the power and signal cables.
7.
("Unlock the tower bezel" on page 26).
("Access panel" on page 26).
("System fan air
("Remove the server from the
baffle" on page 26).
("Hard drive cage fan and
Removal and replacement procedures 35
rack" on page 25).
baffle" on page 28).