Remove the SAS or SATA backplane.
9.
To replace the component, reverse the removal procedure.
Diskette drive
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 25).
1.
Remove the server from the rack, if necessary
2.
Remove the bezel
3.
Remove the access panel
4.
Disconnect the power and data cables.
5.
To prevent improper cooling and thermal damage, do not operate the server unless
("Unlock the tower
bezel" on page 26).
("Access
panel" on page 26).
("Remove the server from the
Removal and replacement procedures 32
rack" on page 25).