HP ProLiant ML310 Generation 4 Maintenance And Service Manual page 38

Remove the access panel
4.
Remove the system fan air baffle
5.
Remove the heatsink.
6.
CAUTION: Heatsink retaining screws should be loosened in diagonally opposite pairs (in an
"X" pattern).
To replace the heatsink:
Use the alcohol swab to remove all the existing thermal grease from the processor. Allow the alcohol
1.
to evaporate before continuing.
Apply new grease to the top of the processor in one of the following patterns to ensure even
2.
distribution.
CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the
heatsink is removed from the processor after it has been installed.
("Access panel" on page 26).
("System fan air baffle" on page 26).
Removal and replacement procedures 38