Hot-Plug Sas And Sata Hard Drive Cage - HP ProLiant ML310 Generation 4 Maintenance And Service Manual

IMPORTANT:
SATA hot-plug capability are not supported with the embedded controller. For full LED and hot-
plug support, an optional SATA RAID or SAS controller must be installed.
Unlock and open the bezel
2.
Remove the hard drive.
3.
To replace the component:
Slide the drive into the cage until it clicks, locking the drive into place.
1.
Close the lever.
2.
IMPORTANT:
drive is seated properly and receiving power.
As the drive begins to spin, be sure that the drive LEDs illuminate one at a time and then turn off
3.
together to indicate that the system has recognized the new drive.
In fault-tolerant configurations, allow the replacement drive to be reconstructed automatically with
data from the other drives. While reconstruction is in progress, the online LED flashes.
NOTE:
per RAID volume.

Hot-plug SAS and SATA hard drive cage

To remove the component:
Power down the server (on page 25).
1.
Remove the server from the rack, if necessary
2.
Remove the bezel
3.
Remove the access panel
4.
Remove all hot-plug hard drives
5.
Remove the hard drive cage fan and baffle
6.
When hot-plug SATA hard drives are installed, SATA LED functionality and full
("Unlock the tower
When the drive is inserted, the drive LEDs flash for 2 seconds to indicate that the
The SATA RAID feature supports up to two RAID volumes with up to four hard drives
("Unlock the tower
("Access panel" on page 26).
("Hot-plug SAS and SATA hard
bezel" on page 26).
("Remove the server from the
bezel" on page 26).
("Hard drive cage fan and
rack" on page 25).
drives" on page 29).
baffle" on page 28).
Removal and replacement procedures 30