Table of Contents
Advertisement
Removal and Replacement Procedures
2.
Remove the access panel. See "Access Panel" in this chapter.
3.
Disconnect the drive assembly cables. See "Drive Assembly" in this chapter.
4.
Unscrew both LED/PWR switch board screws from the drive assembly (1) and remove
the LED/PWR switch board (2).
Figure 2-3: Removing the LED/PWR switch board
IMPORTANT: Carefully remove the LED/PWR switch board to avoid damaging the LEDs.
Reverse steps 1 through 4 to replace the LED/PWR switch board.
Diskette Drive
To remove the diskette drive:
1. Power down the server. See "Powering Down the Server" in this chapter.
2. Remove the access panel. See "Access Panel" in this chapter.
3. Disconnect the drive assembly cables. See "Drive Assembly" in this chapter.
4. Remove the LED/PWR switch board. See "LED/PWR Switch Board" in this chapter.
5. Remove the 4 screws holding diskette drive (1) and slide the drive out of the assembly
(2).
2-8
HP ProLiant DL320 Generation 3 Server Maintenance and Service Guide
Advertisement
Table of Contents
