Connect the data cable to the rear of the drive and to the SCSI controller.
10.
Remove the applicable bezel blanks from the bezel
11.
Install the access panel (on page 18).
12.
Install the bezel.
13.
Power up the server (on page 16).
14.
Diskette drives
A diskette drive can be installed in the server in the following ways:
•
Install a diskette drive in the chassis
•
Install a diskette drive using a USB cable (when using operating systems that support USB)
a USB diskette
Installing a legacy diskette drive
For clarity, the following illustrations include option cabling only.
Power down the server (on page 16).
1.
Remove the bezel (on page 17).
2.
Remove the access panel (on page 18).
3.
Remove the applicable media bay blank
4.
("Installing a legacy diskette
drive" on page 38)
("Remove a bezel
drive" on page 36)
("Remove a media bay
blank" on page 19).
blank" on page 19).
("Installing
Hardware options installation 36