IBM eServer BladeCenter JS20 Installation And User Manual page 85

Checkpoint code Description
E153 End the adapter firmware code
probing and evaluation.
E154 Create the PCI bridge node.
E155 Probing the PCI bridge secondary
bus.
E158 Reserved
E15B Transfer control to the operating
system (service-mode startup).
E15F Adapter vital product data (VPD)
evaluation.
E170 Beginning of the PCI bus probe.
E172 First pass of the PCI device probe.
E174 Establishing the host connection.
Suggested action
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for assistance.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. If the problem remains, you might have a problem
with the system board. Contact a service support
representative for assistance.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. If the problem remains, you might have a problem
with the system board. Contact a service support
representative for assistance.
Contact a service support representative for assistance.
See the BladeCenter JS20 Type 8842 Hardware
Maintenance Manual and Troubleshooting Guide on the
IBM BladeCenter Documentation CD.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. If the problem remains, you might have a problem
with the system board. Contact a service support
representative for assistance.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. If the problem remains, you might have a problem
with the system board. Contact a service support
representative for assistance.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. If the problem remains, you might have a problem
with the system board. Contact a service support
representative for assistance.
1. Make sure that the Boot Internet protocol (BOOTP)
server is configured for this client. Correct any
problems found, then, retry the operation.
2. Make sure that the network connections are correct;
then, retry the operation.
3. Perform the system checkout procedure. See
"System checkout" on page 64.
4. If there are no problems with the BOOTP server or
the network connection, replace the system board.
Contact a service support representative for
assistance.
Chapter 8. Solving problems
69