IBM eServer BladeCenter JS20 Installation And User Manual page 34

Complete the following steps to install a blade server into the BladeCenter unit:
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
10. (Optional) A set of user labels comes with the blade server. Write identifying
11. If you have other blade servers to install, do so now.
18
BladeCenter JS20 Type 8842: Installation and User's Guide
1. Read the safety information beginning on page vii and "Installation guidelines"
on page 21.
2. If you have not done so already, install any options needed, such as disk
drives or memory, in the blade server.
3. Select the bay for the blade server.
4. Remove the filler blade from the bay that you selected. For future use, store
the filler blade in a static-protective environment.
5. Make sure that the release levers on the blade server are in the open position
(perpendicular to the blade server).
6. Slide the blade server into the bay until it stops. The spring-loaded doors
further back in the bay that cover the bay opening move out of the way as you
insert the blade server.
7. Push the release levers on the front of the blade server closed.
8. Turn on the blade server. See "Turning on the blade server" on page 13 for
instructions.
9. The power-on LED on the blade control panel first flashes rapidly and then
slowly. Make sure that the power-on LED is lit continuously (steady), indicating
that the blade server is receiving power and is turned on.
information on one of the user labels for the blade server; then, place the label
on the BladeCenter unit bezel just below the blade server, as shown in the
following illustration.
Attach here
Important: Do not place the label on the blade server or in any way block the
ventilation holes on the blade server.