IBM eServer BladeCenter JS20 Installation And User Manual page 89

Checkpoint code Description
E1C5 Create the ISA interrupt controller
(PIC) node.
E1C6 Create the direct memory access
(DMA) node.
E1DB Reserved
E1DC Reserved
E1F0 Start the out-of-box-experience
function.
E1F1 Begin the self-test sequence on
startup devices.
E1F2 Reserved
E1F3 Reserved
E1F4 End the self-test sequence on startup
devices.
E1F5 Build the boot list.
E1F6 Determine the startup-device
sequence.
E1F7 No startup image located.
Suggested action
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
Have the blade server serviced.
Have the blade server serviced.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
Have the blade server serviced. Contact a service
support representative for assistance.
Have the blade server serviced. Contact a service
support representative for assistance.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 64.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Make sure that the boot list is applicable by using
the management-module boot list menu.
2. Perform the system checkout procedure. See
"System checkout" on page 64.
3. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
See the BladeCenter JS20 Type 8842 Hardware
Maintenance Manual and Troubleshooting Guide on the
IBM BladeCenter Documentation CD.
Chapter 8. Solving problems
73