Basic Sewing Procedures
Cording
* The cording foot accessory is optional. It is not included with this machine.
Sew over one strand of cording to create a pretty swirled
design on a jacket or vest or sew over three strands of cord-
ing for border trims. Pearl cotton, knitting yarn, embroidery
floss, lace thread, fine wool or lily yarn can be used for cord-
ing.
Single cording
Mark the design on the fabric. Insert the cord in the
•
center groove of the cording foot from the right side
opening.
Pull the cord about 5cm (2 inches) behind the foot.
•
•
The grooves under the foot will hold the length of the
cord in place while the stitches are being formed over
the cord.
•
Select the stitch and adjust the stitch width so that the
stitches just cover the cord.
•
Lower the foot and sew slowly, guiding the cord over
the design.
Triple cording
•
Push the sewing thread to the left and insert three
cords into the grooves of the foot and pull about 5cm
(2 inches) of the cords behind the foot.
•
Select the desired pattern and adjust the stitch width
so that the stitches just cover the cords. Lower the foot
and sew slowly guiding the cords.
56
5
6
6
502020.83.11_2013_06_bernette chicago 7_EN
A-09
A-28
A-09
A-28
5
5
6
A-09
A-28
6
A-09
A-28