Bernette Chicago 7 Instruction Manual page 15

A !
tteNtioN
Start by raising the needle to its highest point, and also raise
the presser foot to release the tension discs.
• Place the thread spool on the spool pin so that the
thread comes from the front of the spool, then place
the spool cap at the end of the spool pin.
• Pull the thread from the spool through the upper thread
guide.
Guide the thread around the thread guide pulling the
•
thread through the pre-tension spring as illustrated
Then lead it further down and around the bottom part
•
of the take-up lever cover.
Pull it up and insert the thread from the right to the left
•
through the slotted eye of the take-up lever and then
take it downwards again.
Guide the thread through the wire loop.
•
• Pull the end of the thread through the needle from the
front to the rear, and pull out about 10 cm of thread.
Use the face plate thread cutter to cut excess needle
•
thread.
Use the needle threader to thread the needle (refer to
•
next page for instruction).
502020.83.11_2013_06_bernette chicago 7_EN
Machine Setup
13