Walking Foot - Bernette Chicago 7 Instruction Manual

Walking Foot

* The walking foot accessory is optional. It is not included with
this machine.
Always try to sew without the walking foot accessory first
as it should be used only when necessary.
It is easier to guide the fabric and you have a better view of
the seam when using the standard, regular foot on your
machine.
Your sewing machine offers excellent stitch quality on a wide
range of fabrics from delicate chiffons to multiple layers of
denim.
The Walking foot accessory equalizes the feeding of the upper
and lower layers of fabric and improves the matching of
plaids, stripes and patterns. It also helps to prevent uneven
feeding of very delicate fabrics.
• Lift the presser foot lifter to raise the presser foot bar.
Remove the presser foot holder by unscrewing the
•
presser foot bar attaching screw counter-clockwise.
Attach the Walking foot to the machine as follows:
• The arm (a) should fit into the needle attaching screw
and clamp (b) above.
• Slide the plastic attaching head (c) from the left to the
right so that it fits into the presser foot bar.
• Lower the presser foot bar.
Replace and tighten (clockwise) the presser bar attach-
•
ing screw.
• Make sure both the needle attaching screw and the
presser foot bar attaching screw are tightly fixed.
• Draw the bobbin thread up and place both the bobbin
thread and the needle thread behind the walking foot
attachment.
502020.83.11_2013_06_bernette chicago 7_EN
Basic Sewing Procedures
a
a
b
a
b
b
c
c
c
a
b
a
c
b
c
65