Verifying Your Configuration - Cisco ASR 5x00 Administration Manual

▀ Verifying Your Configuration

Verifying Your Configuration
This section explains how to display and review the configurations after saving them in a .cfg file as described in the
System Administration Guide and also to retrieve errors and warnings within an active configuration for a service.
Important:
These instructions are used to verify the Subscriber Session Trace configuration.
Step 1
Verify that your subscriber session support is configured properly by entering the following command in Exec Mode:
show session trace statistics
The output of this command displays the statistics of the session trace instance.
Step 2 View the session trace references active for various network elements in an EPC network by entering the following
command in Exec Mode:
show session trace trace-summary
The output of this command displays the summary of trace references for all network elements:
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
222
All commands listed here are under Exec mode. Not all commands are available on all platforms.
Num current trace sessions: 5
Total trace sessions activated: 15
Total Number of trace session activation failures: 2
Total Number of trace recording sessions triggered: 15
Total Number of messages traced: 123
Number of current TCE connections: 2
Total number of TCE connections: 3
Total number of files uploaded to all TCEs: 34
MME
Trace Reference: 310012012345
Trace Reference: 310012012346
SGW
Trace Reference: 310012012345
Trace Reference: 310012012346
PGW
Configuring Subscriber Session Tracing