Verifying Hnb-Gw Configuration - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

HNB-GW Service Configuration Procedures
hnb-access-mode open max-registered-ue <reg_ue>
paging open-hnb [ hnb-where-ue-registered fallback ] {always | never | only-if-
with-paging-area}
end
Notes:
 <
vpn_ctxt_name
 <
hnbgw_svc_name
 <
reg_ue
default 16 UEs are allowed.

Verifying HNB-GW Configuration

This section shows the configuration parameters configured for HNB-GW service.
Step 1
Verify that your HNB-GW services were created and configured properly by entering the following command in Exec
Mode:
show hnbgw-service hnbgw-service <hnbgw_svc_name>}
The output of this command displays concise listing of HNB-GW service parameter settings as configured on
system.
Step 2
Verify configuration errors of your HNB-GW services by entering the following command in Exec Mode:
show configuration errors section hnbgw-service}
The output of this command displays current configuration errors and warning information for the target
configuration file as specified for HNB-GW service
OL-25069-03
> is name of the source context in which HNB-GW service is configured.
> is name of the HNB-GW service in which Open Access mode support is to be configured.
> is number of the UEs allowed to be registered through open HNB in Open Access Mode support. By
Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide ▄
HNB-GW Service Configuration ▀
85