P-Gw Service Configuration - Cisco ASR 5x00 Administration Manual

▀ Configuring the System as a Standalone eGTP P-GW
context <pgw_context_name>
gtpu-service <gtpu_service_name> -noconfirm
bind ipv4-address <s5s8_interface_address>
end
Notes:
 The
bind
Creating a P-GW PDN Context
Use the following example to create a P-GW PDN context and Ethernet interface, and bind the interface to a configured
Ethernet port.
configure
context <pdn_context_name> -noconfirm
interface <sgi_ipv4_interface_name>
ip address <ipv4_address>
interface <sgi_ipv6_interface_name>
ipv6 address <address>
end

P-GW Service Configuration

Step 1
Configure the P-GW service by applying the example configuration in the
Step 2
Specify an IP route to the eGTP Serving Gateway by applying the example configuration in the
Route section.
Configuring the P-GW Service
Use the following example to configure the P-GW service:
configure
context <pgw_context_name>
pgw-service <pgw_service_name> -noconfirm
plmn id mcc <id> mnc <id>
associate egtp-service <egtp_service_name>
associate qci-qos-mapping <name>
end
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
120
command can also be specified as an IPv6 address using the
PDN Gateway Configuration
command.
ipv6-address
Configuring the P-GW Service
Configuring a Static IP
section.