Configuring Plmn And Time Zone Reporting - Cisco ASR 5x00 Administration Manual

▀ Configuring Gy Interface Support
context <context_name>
Notes:
 For information on configuring IP access lists, refer to the Access Control Lists chapter in the Systems
Administration Guide.
 For more information on configuring ECS ruledefs, refer to the ACS Ruledef Configuration Mode Commands
chapter in the Command Line Interface Reference.
 For more information on configuring ECS charging actions, refer to the ACS Charging Action Configuration
Mode Commands chapter in the Command Line Interface Reference.
 For more information on configuring ECS rulebases, refer to the ACS Rulebase Configuration Mode Commands
chapter in the Command Line Interface Reference.

Configuring PLMN and Time Zone Reporting

PLMN and Time Zone Reporting feature requires a credit-control group to be defined in the APN or subscriber
configuration or there must be a default credit-control group configured. The following CLI commands are available to
enable/disable PLMN and Time Zone Reporting feature:
To enable PLMN and Time Zone Reporting through subscriber-template, use the following configuration:
configure
context <context_name>
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
370
pending-traffic-treatment noquota buffer
pending-traffic-treatment quota-exhausted buffer
exit
exit
subscriber default
ip access-group <acl_name> in
ip access-group <acl_name> out
ip context-name <context_name>
active-charging rulebase <rulebase_name>
credit-control-group <cc_group_name>
end
subscriber name <subscriber_name>
dns primary <primary_ipaddress>
dns secondary <secondary_ipaddress>
ip access-group test in
Gy Interface Support