Verifying And Saving Your Configuration - Cisco VG202 Hardware Installation Manual

Chapter 4 Powering On the Voice Gateway and Performing the Initial Configuration
The system displays a summary of the available interfaces.
Choose one of the available interfaces for connecting the voice gateway to the management network:
Step 9
Enter interface name used to connect to the
management network from the above interface summary: fastethernet4
Respond to the following prompts as appropriate for your network:
Step 10
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]: yes
The system displays the configuration:
The following configuration command script was created:
hostname VG
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
speed 100
duplex auto
ip address 172.1.2.3 255.255.0.0
!
Respond to the following prompts. Enter 2 to save the initial configuration.
Step 11
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
VG>

Verifying and Saving Your Configuration

To verify the configuration and save it in NVRAM so that the configuration remains in effect after you
restart the voice gateway, enter the following commands:
OL-15959-01
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 26 subnet bits; mask is /16
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide
Performing the Initial Configuration
4-5