Radius Attributes; Traffic Policing For Cdma Subscribers - Cisco ASR 5x00 Administration Manual

▀ RADIUS Attributes

RADIUS Attributes

Traffic Policing for CDMA Subscribers

The RADIUS attributes listed in the following table are used to configure Traffic Policing for CDMA subscribers
(PDSN, HA) configured on remote RADIUS servers. More information on these attributes can be found in the AAA
Interface Administration and Reference.
Table 47.
Attribute Description
SN-QoS-Tp-Dnlk Enable/disable traffic policing in the downlink direction.
(or SN1-QoS-Tp-
Dnlk)
SN-Tp-Dnlk- Specifies the downlink committed-data-rate in bps.
Committed-Data-
Rate
(or SN1-Tp-Dnlk-
Committed-Data-
Rate)
SN-Tp-Dnlk-Peak- Specifies the downlink peak-data-rate in bps.
Data-Rate
(or SN1-Tp-Dnlk-
Committed-Data-
Rate)
SN-Tp-Dnlk-Burst- Specifies the downlink-burst-size in bytes.
Size
NOTE: It is recommended that this parameter be configured to at least the greater of the following two
(or SN1-Tp-Dnlk- values: 1) 3 times greater than packet MTU for the subscriber connection, OR 2) 3 seconds worth of token
Burst-Size) accumulation within the "bucket" for the configured peak-data-rate.
SN-Tp-Dnlk- Specifies the downlink exceed action to perform.
Exceed-Action
(or SN1-Tp-Dnlk-
Exceed-Action)
SN-Tp-Dnlk- Specifies the downlink violate action to perform.
Violate-Action
(or SN1-Tp-Dnlk-
Violate-Action)
SN-QoS-Tp-Uplk Enable/disable traffic policing in the downlink direction.
(or SN1-QoS-Tp-
Uplk)
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
518
RADIUS Attributes Required for Traffic Policing Support for CDMA Subscribers
Traffic Policing and Shaping