Configuring Ggsn / P-Gw Rf Interface Support - Cisco ASR 5x00 Administration Manual

Rf Interface Support
 Prior to creating the Active Charging Service (ACS), the
configured to enable ACS functionality.
 The
billing-records rf
sessions. Rf accounting is applicable only for dynamic and predefined ACS rules.
For more information on the rules and its configuration, refer to the ACS Charging Action Configuration Mode
Commands chapter in the Command Line Interface Reference.
 The
active-charging rf
rules, predefined ACS rules, and static ACS rules for Rf-based accounting. As this CLI configuration is applied
at the rulebase level, all the APNs that have the current rulebase defined will inherit the configuration.
For more information on this command, refer to the ACS Rulebase Configuration Mode Commands chapter in
the Command Line Interface Reference.

Configuring GGSN / P-GW Rf Interface Support

To configure the standard Rf interface support for GGSN/P-GW, use the following configuration:
configure
context <context_name>
apn <apn_name>
associate accounting-policy <policy_name>
exit
policy accounting <policy_name>
accounting-event-trigger { cgi-sai-change | ecgi-change | flow-information-
change | interim-timeout | location-change | rai-change | tai-change } action { interim |
stop-start }
accounting-keys qci
accounting-level { flow | pdn | pdn-qci | qci | sdf | subscriber }
cc profile index { buckets num | interval seconds | sdf-interval seconds | sdf-
volume { downlink octets { uplink octets } | total octets | uplink octets { downlink
octets } }
| volume { downlink octets { uplink octets } | total octets | uplink octets { downlink
octets } } }
max-containers { containers | fill-buffer }
end
Notes:
 The policy can be configured in any context.
 For information on configuring accounting levels/policies/modes/event triggers, refer to the Accounting Policy
Configuration Mode Commands chapter in the Command Line Interface Reference.
command configures Rf record type of billing to be performed for subscriber
command is used to enforce a specific rating group / service identifier on all PCC
| serving-nodes num | tariff time1 min hrs [ time2 min hrs...time4 min hrs ]
require active-charging
Cisco ASR 5x00 Packet Data Network Gateway Administration Guide ▄
Configuring Rf Interface Support ▀
command should be
475