Verifying And Saving Your Configuration; Troubleshooting - Cisco VG224 - Analog Phone Gateway Hardware Installation Manual

Troubleshooting

Verifying and Saving Your Configuration

To verify the configuration and save it in NVRAM so that the configuration remains in effect if the
Cisco VG224 is restarted, enter the following commands:
Command
Step 1
Router# show running-config
Step 2
Router# show startup-config
Step 3
Router# show controller t1 1/0
Step 4
Router# copy running-config startup-config
Troubleshooting
This section describes possible mechanical problems and corrective actions.
If there appears to be a malfunction, first check all cables and connections. If these are in order, see
Table 4-1
For problems with the configuration, refer to the
Guide
http://cisco.com/en/US/docs/routers/access/vg224/software/configuration/guide/scg.html
Cisco VG224 Voice Gateway Hardware Installation Guide
4-4
for specific troubles and solutions.
at the following URL:
Chapter 4
Purpose
Displays the current operating configuration, including any
changes you have just made.
Displays the configuration currently stored in NVRAM.
Displays the configuration of the T1 network interface controller.
Slot and port may vary.
Writes the current running configuration to NVRAM, where it
overwrites the startup configuration and becomes the new startup
configuration.
If you reboot the Cisco VG224 voice gateway or turn off
Note
the power before you complete this step, you lose the
configuration.
Cisco VG224 Voice Gateway Software Configuration
Powering On the Cisco VG224 Voice Gateway
OL-5006-04