Table of Contents
Advertisement
▀ Configuring the System as a Standalone PMIP P-GW in an LTE-SAE Network
Required
Description
Information
Gateway IP
Used when configuring static IP routes from the interface(s) to a specific network.
address
Gx Diameter Endpoint Configuration
End point name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the Gx Diameter endpoint
configuration is recognized by the system.
Origin realm
An identification string between 1 through 127 characters.
name
The realm is the Diameter identity. The originator's realm is present in all Diameter messages and is typically
the company or service name.
Origin host name
An identification string from 1 to 255 characters (alpha and/or numeric) by which the Gx origin host is
recognized by the system.
Origin host
The IP address of the Gx interface.
address
Peer name
The Gx endpoint name described above.
Peer realm name
The Gx origin realm name described above.
Peer address and
The IP address and port number of the PCRF.
port number
Route-entry peer
The Gx endpoint name described above.
S6b Interface Configuration (to 3GPP AAA server)
Interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and
IPv4 or IPv6 addresses assigned to the interface.
subnet
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port
The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
number
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP
Used when configuring static IP routes from the interface(s) to a specific network.
address
S6b Diameter Endpoint Configuration
End point name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the S6b Diameter endpoint
configuration is recognized by the system.
Origin realm
An identification string between 1 through 127 characters.
name
The realm is the Diameter identity. The originator's realm is present in all Diameter messages and is typically
the company or service name.
Origin host name
An identification string from 1 to 255 characters (alpha and/or numeric) by which the S6b origin host is
recognized by the system.
Origin host
The IP address of the S6b interface.
address
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
140
PDN Gateway Configuration
Advertisement
Table of Contents
