Cisco ASR 5x00 Administration Manual page 166

▀ Configuring the System as a Standalone PMIP P-GW Supporting an eHRPD Network
Step 3
Create and configure APNs in the P-GW context by applying the example configuration in the
Configuring APNs in the P-GW Context
Step 4
Create and configure AAA server groups in the P-GW context by applying the example configuration in the
and Configuring AAA Groups in the P-GW Context
Step 5
Create an eGTP service within the newly created context by applying the example configuration in the
Configuring an LMA Service
Step 6
Create a context through which the interface to the PDN will reside by applying the example configuration in the
Creating a P-GW PDN Context
Modifying the Local Context
Use the following example to set the default subscriber and configure remote access capability in the local context:
configure
context local
interface <lcl_cntxt_intrfc_name>
ip address <ip_address> <ip_mask>
exit
server ftpd
exit
server telnetd
exit
subscriber default
exit
administrator <name> encrypted password <password> ftp
ip route <ip_addr/ip_mask> <next_hop_addr> <lcl_cntxt_intrfc_name>
exit
port ethernet <slot#/port#>
no shutdown
bind interface <lcl_cntxt_intrfc_name> local
end
Creating and Configuring a P-MIP P-GW Context
Use the following example to create a P-GW context, create an S2a IPv6 interface (for data traffic to/from the HSGW),
and bind the S2a interface to a configured Ethernet port:
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
166
section.
section.
section.
section.
PDN Gateway Configuration
Creating and
Creating
Creating and