Installing The Cisco Ipvc 3526 Pri Gateway In A Rack; Installing The Cisco Ipvc 3540 Pri Gateway - Cisco 3521 Administrator's Manual

Chapter 2 Installing the Cisco IPVC 3500 Series Gateway

Installing the Cisco IPVC 3526 PRI Gateway in a Rack

You can install the Cisco IPVC 3526 PRI Gateway in a 19-inch rack. The mounting kit supplied with the
gateway includes two brackets for mounting the unit on a rack. This section describes how to install the
mounting brackets.
Procedure
Place the unit the right way up on a hard flat surface, with the front panel facing you.
Step 1
Position a mounting bracket over the mounting holes on one side of the unit (see
Step 2
Figure 2-2
Step 3 Pass the three screws through the washers and bracket holes into the gateway, and tighten them securely
with a screwdriver.
Step 4 Repeat Steps 2 and 3 for the other side of the gateway.
Insert the unit into the 19-inch rack and secure.
Step 5
Two screws are needed for each side. These screws are not provided.
Note

Installing the Cisco IPVC 3540 PRI Gateway

The Cisco IPVC 3540 PRI Gateway has two components that you must install in the
Cisco IPVC 3544 chassis: the Cisco IPVC 3540 PRI Gateway module and the PRI rear transition
module (RTM). These modules complement each other. The gateway module installs in the front of the
chassis and provides PRI functionality. The RTM installs in the rear of the chassis and provides the
physical interface for the PRI line. You must install these modules in corresponding slots in the chassis.
That is, if you insert the gateway module in the top slot in the front of the chassis, you must insert the
RTM in the top slot in the rear of the chassis.
The Cisco IPVC 3544 chassis uses a cPCI bus and requires a module with system functionality in the
top slot. This system functionality is embedded in the gateway module and is activated only when the
gateway module is installed in the top slot.
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Mounting Bracket Installation
Make sure that the air vents in the sides of the unit are not blocked.

Installing the Cisco IPVC 3526 PRI Gateway in a Rack

Figure 2-2).
2-5