Configuring Bri Or Pri Port Supported Services; Viewing Call Information - Cisco 3521 Administrator's Manual

Viewing Call Information

In the Outgoing Calling Party Number field, enter a number that the gateway automatically provides
Step 8
if the calling IP network endpoint does not provide a calling party number. Valid digits are 0 through 9
You can enter up to 11 digits.

Configuring BRI or PRI Port Supported Services

In the Supported Services section of the BRI Port or PRI Port tabs, you can enable or disable specific
gateway services on each BRI or PRI port. The Supported Services section displays the following
information in table form:
•
•
•
•
•
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already selected).
Step 1
Step 2 Click the applicable BRI Port or PRI Port tab.
Step 3 Click the Supported Services button.
Select the Same as Port check box if you want to duplicate settings from another BRI or PRI port that
Step 4
you choose from the field. When selected, you cannot modify any settings in this section. This option is
unavailable in gateways that support only one BRI or PRI port.
Step 5 To enable or disable a service for this BRI or PRI port, select it and click Enable or Disable.
Viewing Call Information
The Calls tab displays a list of the calls currently defined in the Cisco IPVC 3500 Series Gateway and
the basic details of each call. The Calls tab displays the following information in table format:
•
•
•
•
•
•
•
The following topics discuss the tasks you can perform in this tab:
•
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
3-50
Prefix—Displays the prefix for this service.
Description—Displays a brief description of the service.
Call Type—Displays the call media type: Voice or Video.
Bit Rate—Displays the maximum total bit rate allowed for this service.
Support—Displays the status of the service: enabled or disabled.
Call ID—Displays the call identifier.
Source Party Number—Displays the alias that identifies the source endpoint of the call.
Destination Party Number—Displays the alias that identifies the destination endpoint of the call.
Start Time—Displays the time at which the call began.
Total Call Bandwidth—Displays the total bandwidth (in Kbps) used for this call on both sides.
Encryption—Indicates the level of encryption currently in use for the specified participant: best
effort, encryption required, or strong encryption required.
Total—Field indicates the total number of calls currently defined in the gateway.
Refreshing Call Information, page 3-51
Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
OL-7995-01