Adding Or Editing Services - Cisco 3521 Administrator's Manual

Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
•
•
•
•
•
•

Adding or Editing Services

In the Services tab, you can add a new service or edit an existing one.
Procedure
Step 1 In the Gateway interface, on the sidebar, click Gateway (if not already selected).
Click the Services tab.
Step 2
To add a new service, click Add. To edit an existing service, select it and then click Edit.
Step 3
In the Prefix field, enter or edit the prefix number of the service. The prefix can be up to 31 characters
Step 4
long. Valid characters are 0 to 9 and pound sign (#), asterisk (*), and comma (,).
Note
In the Description field, enter or edit the description of the service (up to 31 characters in length).
Step 5
In the Call type field, select the call type for this service: Video or Voice.
Step 6
In the Bit rate field, select the maximum bit rate you want for this service. If you select Auto, the
Step 7
gateway determines the ISDN call rate according to the bearer capability received in the setup message
from the IP network endpoint.
Note
If the IP network endpoint has a configured bit rate that is not one of the options listed in this field, the
gateway uses the default bit rate configured in the Default Service Bit Rate field in the Advanced
section of the Settings tab.
Note
Click Advanced to configure bonding synchronization settings.
Step 8
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Prefix—Displays the prefix that identifies the service.
Description—Description of the service.
Call Type—Media type of the call.
Bit Rate—Total bandwidth requested for the service.
BRI Port 1 to 4/PRI Port 1 or 2—Indicates whether or not the service is enabled for the specified
BRI or PRI port.
Total—Displays the total number of services currently defined in the gateway.
Since the comma cannot be used in the Party number field of the Cisco IPVC 35xx MCU
Conference Control interface, we recommend that you do not use the comma as a prefix in
gateway fields.
The Auto setting is for video calls only.
If the Ignore caller bearer rate and force service rate field is selected when you define a bit
rate for a service, the service uses the defined bit rate. If the Ignore caller bearer rate and force
service rate is unselected, the bit rate you define serves as the maximum limit for that service.
Configuring Gateway Settings
3-35