Deleting Gateway Services; Configuring Bri Or Pri Port Settings - Cisco 3521 Administrator's Manual

Configuring Gateway Settings
Note
The Advanced dialog box appears.
In the Bonding Synchronization field, choose a bonding synchronization setting. Select Prolong only
Step 9
for endpoints that use non-standard synchronization mechanisms.
Click OK to save your setting and close the Advanced dialog box.
Step 10
Click the Port Specific tab.
Step 11
In the Enable service in ports section, select the BRI or PRI ports that are enabled for this service.
Step 12
Click OK.
Step 13
The Gateway interface uploads your settings to the services database.

Deleting Gateway Services

In the Settings tab, you can delete existing services.
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already selected).
Step 1
Click the Services tab.
Step 2
Select a service and click Delete.
Step 3

Configuring BRI or PRI Port Settings

In the BRI Port or PRI Port tabs, you can configure physical line settings for BRI or PRI ports. The
following topics discuss the settings you can configure for BRI or PRI Ports.
•
•
•
•
•
•
•
Note Some configuration options are unavailable in gateways that support only one PRI port.
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
3-36
You can only configure bonding synchronization settings if you send the ServiceOption
advanced command with a parameter of Enable.
Configuring Basic BRI or PRI Port Settings, page 3-37
Configuring BRI Port Physical Interface Settings, page 3-37
Configuring PRI Port Physical Interface Settings, page 3-39
About Advanced ISDN Settings for PRI Gateways, page 3-40
Figure 3-4Network Specific Facility Information Element Format, page 3-42
Configuring BRI or PRI Port Call Policies, page 3-49
Configuring BRI or PRI Port Supported Services, page 3-50
Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
OL-7995-01