Setting The Gateway Location; Resetting Default Board Basic Settings - Cisco 3521 Administrator's Manual

Chapter 2 Installing the Cisco IPVC 3500 Series Gateway
To change the date and time, perform the following steps:
Step 4
a.
b.
c.
d.

Setting the Gateway Location

You can install the gateway anywhere on your network including at a remote site. The Basics tab of the
Board section in the Gateway interface provides a field that you can use to identify the location where
the gateway is located
Procedure.
Step 1 On the sidebar, click Board.
Step 2 Click the Basics tab.
Step 3 In the Location field, enter the location information about the gateway that you want to display.
The field displays up to 23 characters.
On the toolbar, click Upload to save to configuration memory.
Step 4

Resetting Default Board Basic Settings

In the Basics tab of the Board section of the Gateway interface, you can restore board basic settings to
factory defaults.
Procedure
On the sidebar, click Board.
Step 1
Click the Basics tab.
Step 2
Step 3 Select the Reset to default settings check box.
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
In the Change field, select the unit that you want to change.
In the Set board time to field, click the up or down arrow to change that unit.
There is no unit to change AM and PM. This designation rolls automatically when the hour
Note
rolls past 12 backward or forward. Similarly, seconds rolls minutes, minutes roll hours,
hours roll days, and days rolls months.
Repeat steps a-b for each unit you want to change.
On the toolbar, click Upload to save your changes.
Viewing Board Basic Parameters
2-17