Cisco 3521 Administrator's Manual page 87

Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
Table 3-8
Field or Check Box
IP to ISDN Calls section
Conceal caller ID
Ignore caller bearer rate and force service rate Select to configure the gateway to ignore the
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Advanced Settings
Configuring Gateway Settings
Description
Select to have the gateway hide the identifier of
the calling endpoint on the IP network, regardless
of whether the Support Presentation Restriction
advanced setting is selected. The callerID field of
the Q.931 message is sent over the ISDN network
empty.
incoming call bearer rate and to use instead the
bandwidth specified for the service in the Services
tab to process the call. If the service bit rate is set
to Auto, the gateway process the call at the bearer
rate.
Unselect to allow an administrator to limit a
specific service to a maximum bit rate. When
unselected and the bearer rate is greater than the
service rate, the gateway processes the call at the
service rate. When unselected and the bearer rate
is lower than or equal to the service rate, the
gateway processes the call at the bearer rate. If the
bearer bit rate is set to Auto, the gateway process
the call at the bearer rate.
3-25