Configuring Gateway Resources For Calls - Cisco 3521 Administrator's Manual

Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
Table 3-6 Cisco IPVC 3500 PRI Gateway SNMP Trap Event Types (continued)
Event Type
Incompatible sw version
install
Call from non-peer H.323
entity rejected
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already selected).
Step 1
Click the Settings tab.
Step 2
Click the Alert Indications button.
Step 3
In the Events section, select events in the Disabled events field and click Add to select an event to
Step 4
monitor. Or, select an event in the Enabled events field and click Remove to remove that event from
monitoring.
Select the Send SNMP Traps to check box to configure the IP address of the SNMP server to which the
Step 5
gateway sends SNMP trap notifications of the events selected in the Enabled events field. You can
configure up to three different SNMP trap servers.
In the Trap server IP and Port fields, enter the IP address and port number for each SNMP server you
Step 6
want to configure the gateway to send SNMP trap notifications to. To remove an SNMP server, select
those entries and press the delete key on your keyboard.

Configuring Gateway Resources for Calls

This section applies only to Cisco IPVC 3500 PRI Gateways.
Note
In the Resources section of the Settings tab, you can reserve gateway resources for T.120 enabled calls
and for audio transcoded video calls. This section also displays the total number of calls that the gateway
supports at specified bandwidths.
The gateway provides full end-to-end T.120 data collaboration sessions, provided that all terminals
support the T.120 standard in their conferencing applications. In video calls with data transfer, the
gateway accepts whatever bandwidth the ISDN connection defines for the data and dynamically adjusts
the outgoing bandwidth used for data by using the MLP, HMLP, and VarMLP formats.
You can also configure the gateway to prioritize the transcoding, giving preference to a particular codec
that is applied to calls, thus optimizing the resource allocation utilized by each call.
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Trap Name
incompatibleSwBurnAttemp
peerCallRejectedNonPeer
Trap
Trap is sent when...
OID
RV
.0.73
An attempt to burn a
version of the gateway
software onto
incompatible hardware
occurs.
RV
.0.75
The gateway has rejected
an incoming IP call
because the source does
not appear in the peer list.
Configuring Gateway Settings
State Severity
Warning
Warning
3-21