Using The Hyperterminal Configuration Commands - Cisco 3521 Administrator's Manual

Chapter 5 Troubleshooting the Cisco IPVC 3500 Series Gateway
Table 5-1
LED
Link LED
Connectivity LED
GK Reg LED
CD LED
Alarm LED
ACT LED
ACT 1 LED
ACT 2 LED
ACT 3 LED
ACT 4 LED

Using the Hyperterminal Configuration Commands

This section describes configuration commands that you can access through the
Cisco IPVC 3500 Series Gateway serial port. You can use some of these commands to set device
parameters that are unavailable in the Gateway interface. This section describes how to use the
hyperterminal do the following:
•
•
•
•
•
•
•
•
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
LED Monitoring Tab LEDs
Description
This LED located nearest to the model number on the front panel lights green
when there is an Ethernet connection between the gateway device and the
network.
This LED indicates the type of Ethernet interface that is used. The LED lights
green when the Ethernet interface is 100BaseT. The LED is off when the
Ethernet interface is 10BaseT.
The LED lights green when the gateway has an active registration with the
gatekeeper.
This LED lights green when the connection between the gateway and BRI or
PRI line is active.
This LED lights orange when the gateway fails the self test during boot
sequence or when there is a loss of frame alignment.
This LED lights green when there is call activity.
This LED lights green when there is call activity on BRI or PRI port 1.
This LED lights green when there is call activity on BRI port 2.
Note
This LED lights green when there is call activity on BRI port 3.
Note
This LED lights green when there is call activity on BRI port 4.
Note
Accessing Device Commands through the Serial Port, page 5-8
Changing a Global User Name and Password, page 5-8
Setting Echo Cancellation, page 5-9
Configuring the Web Server Port, page 5-9
Configuring BRI Ports, page 5-10
Setting T.120 Data Collaboration Capability, page 5-11
Restoring the Factory Default Settings, page 5-11
Configuring the Ethernet Port, page 5-12
This LED appears only on Cisco IPVC 3521 BRI Gateways.
This LED appears only on Cisco IPVC 3521 BRI Gateways.
This LED appears only on Cisco IPVC 3521 BRI Gateways.
(Cisco IPVC 3521 BRI Gateways only)
(Cisco IPVC 3521 BRI Gateways only)
Using the Hyperterminal Configuration Commands
5-7