Installing The Cisco Vg224 Voice Gateway In A Rack - Cisco VG224 - Analog Phone Gateway Hardware Installation Manual

Rack-Mounting the Chassis

Installing the Cisco VG224 Voice Gateway in a Rack

The following warning applies only when the unit is rack-mounted:
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Statement 1006
To rack-mount the chassis, follow this procedure:
Choose one of the methods shown in
Step 1
page
Make sure to use the correct screws for this mounting option (see
Caution
Screws are included for attaching the brackets to the chassis, but not for installing the chassis in a rack
or on a wall. You need four additional machine screws to install the chassis in a rack. Use the screw size
required by your rack. After the brackets are secured to the chassis, you can rack-mount the chassis.
Using screws that you provide, attach the chassis to the rack as shown in
Step 2
Figure 3-6
Cisco VG224 Voice Gateway Hardware Installation Guide
3-8
3-7, and attach the long leg of the mounting brackets to the chassis, as shown.
Attaching the Chassis to the 19-Inch Rack
Chapter 3
Figure 3-3 on page 3-7, Figure 3-4 on page
VG 22 4
Installing the Cisco VG224 Voice Gateway
3-7, or Figure 3-5 on
Table 3-1 on page 3-6).
Figure 3-6 on page 3-8.
OL-5006-04