Installing The Cisco Ipvc 3540 Pri Gateway Module - Cisco 3521 Administrator's Manual

Installing the Cisco IPVC 3540 PRI Gateway
Warning
Snap the latch handles forward to secure the module in the slot.
Step 8
Secure the PRI RTM screws.
Step 9
Warning

Installing the Cisco IPVC 3540 PRI Gateway Module

Procedure
Perform one of the following:
Step 1
•
•
In the front of the chassis, loosen the screws that secure the latches of the top cover panel.
Step 2
Press the red buttons on each latch and snap the black handles back.
Step 3
Remove the front panel.
Step 4
Remove the gateway module from the antistatic bag.
Step 5
Insert the gateway module in the guide rails of the top slot and slide the module into the slot until the
Step 6
module connector makes contact with the chassis connector (see
Figure 2-4
Press the module firmly into the slot until the face plate is flush with the slot opening.
Step 7
Administrator's Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
2-8
Do not force the connection. Forcing the connection can bend or damage the pins in the
connector inside the chassis.
Blank faceplates and cover panels serve three important functions: they prevent exposure
to hazardous voltages and currents inside the chassis; they contain electromagnetic
interference (EMI) that might disrupt other equipment; and they direct the flow of cooling
air through the chassis. Do not operate the system unless all cards, faceplates, front covers,
and rear covers are in place.
If you are installing the gateway module in the chassis top slot, make sure that the power to the
chassis is off. Skip to Step 5; there is no top-slot front cover.
If you are installing the gateway module in slot two, three, or four, and the power to the chassis is
on, the RTM must be installed before you install the gateway module.
Inserting the Cisco IPVC 3540 PRI Gateway Module
ALA RM 2
REM OTE
LOC AL
CD2
PRI -LIN E ALA RM 1
2
10/1 00B aseT
-2
10/1 00B aseT
-1
REM OTE
LOC AL
CD1
PRI -LIN E
1
Chapter 2
IP/ VC -35 40-
GW 2
CI SC O IP/
VC -35 40
Se rie s
TE MP
Installing the Cisco IPVC 3500 Series Gateway
Figure 2-4).
PO WE R
AL AR M
FA N
OL-7995-01