Removing The Primer - HP DesignJet 250C Service Manual

Removing the Pinch Arm Lever
Linkage
1 Remove the right end cover ' page 6 10.
2 Ease the front plastic part of the linkage
to the right, out from the hole in the right
side plate.
3 Remove the linkage from the cam journal
on the right side plate.
C4699 90000

Removing the Primer

1 Remove the left end cover ' page 6 9.
2 Disconnect the four short tubes from the
ink separator.
3 Remove the screw that attaches the
primer to the left side plate.
4 Slide the primer to the left, and remove it
from the plotter.
Removal and Replacement
Torx-20
6 27