Removing The Service Station - HP DesignJet 250C Service Manual

Removing the Service Station

1 Remove the left end cover ' page 6 9.
2 Disconnect the four short tubes from the
primer ink separator.
3 Remove the screw that attaches the
service station to the left side plate.
Torx-20
6 28 Removal and Replacement
4 Slide the service station to the left, and
remove it from the plotter.
The service station is one orderable assembly.
Do not open it.
Reassembling: Ensure that the cartridge
caps are clean, the wipers straight, and the
openings clear.
C4699 90000