10 Move the carriage back into the service station.
11 Close the top cover.
To adjust the carriage to media distance
You will need to adjust the carriage to media distance if:
D The ledge on the carriage did not pass over the GO side of the gauge. This means that
the carriage is positioned too close to the drive roller.
D The ledge on the carriage did pass over the NO GO side of the gauge. This means that
the carriage is positioned too far from the drive roller.
Adjust the carriage to media distance as follows:
1 Release the two indicated clips on the top of the cartridge carriage by pulling them
slightly outwards.
2 Pull the top of the carriage up.
C4699 90000
W A R N I N G
Take care neither to cut
yourself on the encoder
strip, nor to damage the
strip.
Calibrations and Adjustments
7 13