Removing The Trailing Cable - HP DesignJet 250C Service Manual

Removing the Trailing Cable

1 Remove the right end cover ' page 6 10.
2 Disconnect the trailing cable from the
connector marked P1 on the main PCA,
and from the guides on the right bracket.
C
3 Move the carriage out of the service
station.
6 34 Removal and Replacement
4 Release the two indicated clips on the top
of the cartridge carriage by pulling them
slightly outwards.
C
D
B
W A R N I N G
A
For DesignJet 230 only, it is also necessary to
release two clips at the bottom of the cartridge
carriage.
In the following step, take
care neither to cut yourself
on the encoder strip, nor to
damage the strip.
C4699 90000
230
250C