Removing The Overdrive Roller - HP DesignJet 250C Service Manual

Hewlett packard service manual
Hide thumbs Also See for DesignJet 250C:
Table of Contents

Advertisement

Removing the Overdrive Roller

1 Remove the primer ' page 6 27.
2 Remove the service station ' page 6 28.
3 Remove the clutch retaining ring that
secures the overdrive clutch to the
overdrive roller.
Note the position and orientation of the
overdrive clutch. When correctly
installed, the overdrive roller can be
manually rotated forward only.
4 While flexing the media separator
upwards, ...
... slide the overdrive roller horizontally to
the right until the overdrive clutch can
drop free of the roller.
6 32
Removal and Replacement
5 Move the overdrive roller to the right
until it has completely cleared the left
sideplate but not entered the hole in the
right sideplate.
6 Release the overdrive roller from the
small black clips underneath the media
separator, and remove the overdrive roller
from the plotter.
Reassembling: Position the C clips and
bushings on the overdrive roller from left to
right as follows:
C clip - clutch - bushing - sideplate - bushing - C clip.
C4699 90000

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Designjet 230Designjet 330Designjet 350c

Table of Contents