3 Tighten or loosen the indicated screw on the carriage. This will adjust the carriage angle
on the slider rod, thus increasing or decreasing the carriage to media distance.
Torx-8
4 Check the carriage to media distance ' page 7 11.
5 Reinstall the top of the carriage.
6 Check the trailing cable to make sure that it is positioned under the plastic tabs at the
back of the carriage cover, and not above them.
Trailing cable
under tabs !
Otherwise, the plotter will not be able to load media.
7 14
Calibrations and Adjustments
Rotating
Clockwise
Î Î
Î Î
Î
Î
Gap
Increases
C4699 90000