50 Troubleshooting - HP DesignJet 250C Service Manual

330
Service Configuration Plot for the DesignJet 330 and 350C
350C
The service configuration plot contains the following information:
DesignJet 330/350C Service Configuration Plot
Firmware Release: X.XX.XX
SPROC release: X.X
EEROM Contents
NOTE: All EEPROM Parameters are since last EEROM Reset.
Number of Power Cycles: (Number of times plotter has been switched on.)
Number of Color Plots:
Number of Black Plots:
Number of Pens: (Number of times each cartridge has been replaced. Cyan, Magenta, Yellow, Black.)
Factory Spittoon: (The estimated level of ink in the spittoon. Incorrect if you have cleared the EEROM.)
Number of Bail Errors:
Number of System Errors:
Last System Error: (To correctly interpret this information, refer to page 8-23.)
Last System Error Data: (To correctly interpret this information, refer to page 8-23.)
Bench Run: (Whether the bench run has been performed.)
Bench Run Maximum Y-Axis (Carriage-Axis) PWM: (This should be less than 102. Typical value = 75.)
Bench Run Maximum X-Axis (Media-Axis) PWM: (This should be less than 65. Typical value = 52.)
Encoder-Tests Maximum Y-Axis (Carriage-Axis) PWM: (This should be less than 102. Typical value = 75.)
Encoder-Tests Maximum X-Axis (Media-Axis) PWM: (This should be less than 65. Typical value = 52.)
X-axis Calibration:

8 50 Troubleshooting

(Servo-Processor Code revision number.)
EEROM CONTENTS
(This is for the plotter design engineers to interpret.)
C4699 90000