Reinstalling The Encoder Strip - HP DesignJet 250C Service Manual

11 Carefully pull the encoder strip to the
right, through and out of the carriage
assembly.
12 Lay the encoder strip on a flat surface.

Reinstalling the Encoder Strip

1 Move the cartridge carriage to the left,
over the service station.
2 Ensure that the encoder strip is oriented
with the transparent area up, and with
two holes on the left side and one hole on
the right side.
C4699 90000
W A R N I N G
In the following steps, take
care neither to cut yourself
on the encoder strip, nor to
damage the strip.
3 Feed the encoder strip through the
cartridge carriage from right to left.
4 Temporarily, rest the loose strip safely on
the drive roller.
5 Slip the left end of the strip over the
plastic pin on the left bracket, and press it
right to the base of the pin.
Removal and Replacement 6 19