HP DesignJet 250C Service Manual page 88

7 Remove the engaging lever.
8 Remove the spring from the bail gear
assembly.
9 Loosen the screw from the top of the
bail gear assembly.
Torx-8
6 30 Removal and Replacement
10 Remove the screw from the plastic bail
gear.
You may need to hold the bail cam steady
inside the side plate at the same time. You
can access the cam through the hole
underneath the side plate.
Torx-15
11 Pull the bail gear assembly out from the
plotter.
The cam falls to the floor of the plotter.
C4699 90000