HP DesignJet 250C Service Manual page 101

3 Use the right cam journal to lift the
pinch wheels, and let the roller drop into
place.
4 Ensure that the bearing assembly at the
right end of the drive roller is seated in
the right sideplate and completely on the
right side of the axial bias plate.
C4699 90000
5 Replace the overdrive clips underneath
the media separator.
6 Replace the media mount.
Press down on the media mount as you
replace the three screws. This is to ensure
correct spacing between the drive roller
and the cartridge nozzles.
Press down here as
you tighten screws
Torx-20
Media motor mount
Calibration: Perform the accuracy
calibration after reassembling the plotter.
(Details ' chapter 7.)
Removal and Replacement 6 43