Epson Research and Development
Vancouver Design Center
3 Installation and Configuration
The S5U13700B00C evaluation board incorporates a DIP switch and 9 jumpers, which
allow configuration of the board.
3.1 Configuration DIP Switches
An 8 position DIP switch (S1) is used to configure the S1D13700 for different Host Bus
interfaces and to select the FPSHIFT cycle time. The following figure shows the location
of DIP switch S1 on the S5U13700B00C.
S5U13700B00C Rev. 1.0 Evaluation Board User Manual
Issue Date: 2005/07/15
Top View
Figure 3-1: Configuration DIP Switch (S1) Location
Revision 1.0
DIP Switch - S1
X42A-G-002-01
Page 7
S1D13700